Download Now
argox r-400k pplb Driver

PPLA, PPLB emulations available. • Support 1D/GS1 Data bar, 2D/Composite codes and QR barcodes. • Full range of options:Cutter, Stacker, Font card, g: k ‎ ‎Must include: ‎k. Commercial Label Printer Argox Rplus leads industrial level printers in PPLB: Code39, Code93, Code/subset A, B and C, Codabar, Interleaved 2 of 5, UPC in for Rplus&R, Ribbon would ink-side out for RK plus only). DrvHub uses cookies to improve content and ensure you get the best experience on our website. If you continue to use this site we assume that you accept our.


argox r-400k pplb Drivers (2019)

Type: Driver
Rating:
4.76
208 (4.76)
Downloads: 490
File Size: 9.43Mb
Supported systems: Windows 10, Windows 8.1, Windows 7
Price: Free* [*Free Registration Required]

Download Now
argox r-400k pplb Driver

Hold the print head module upright with one hand to allow the media pass under it. Lead the media through the media guides with the other hand.

The media guides can be adjusted centrality to well fit with different label width. Page 20 8. Turn back the print head module argox r-400k pplb then press it down firmly on both sides till you hear a snap.

argox r-400k pplb Treiber

Print Head Module Page 21 9. Close the top cover and turn on the printer or press feed button if the printer is already on. Feed Button Note: Remove approximate 6" long labels from the backing paper.

ARGOX RPLUS USER MANUAL Pdf Download.

Page 23 2. Trim the edge of label backing paper with scissors or knife. Push down peeler-switch to ease the access packing paper. Lead the backing paper over argox r-400k pplb plate, then thread it back into the slot, ensuring that it is inserted between white plastic roller and plate.

Page 24 6. Latch print head module 7.

立象 Argox 打印机驱动下载

Turn on the printer and press feed button. Labels will be separated from backing paper and fed out on H cover, while argox r-400k pplb paper will come out from the slot under the H cover, and label will be fed out. Mount cutter on print head module by fastening with two screws.

argox r-400k pplb Driver Download (2019)

Thread the media over the platen roller, and then route the media through the slot of the cutter module. Page 26 3.

Press down the print head module firmly. Cutter Note: The "Feed" button will not drive the printer to cut.

The cutting work can be executed only when the software setting is ready. Printer Operations 3.

argox r-400k pplb Driver Download

Argox r-400k pplb indicators display the operation status of the printer. Page 29 occur, especially for small-size labels less than 20mm in height. Before calibration, the media and ribbon must be loaded properly and move the label sensor to correct position.

Performing Calibration Performing Calibration After the media loaded, it is necessary to do the calibration for the label size detection. Press and hold the pause button.

Related Drivers